RFL Communications 21 Sub-MUX Spécifications télécharger pdf (Page 210)

Page 16–6

FOCUS System Manual

Repeat Steps 5–7 for channel B. Be sure to

connect to channel B on both (232) module

interfaces.

To test the 232 modules with modems, complete

the following steps:

1. Install the 232 module and interface.

2. Start the FCS.

3. Bring the FOCUS chassis “on line”.

4. Unlock the FOCUS chassis.

5. Connect the two modems to the modules.

Connect one modem to channel A of the

module interface on one chassis and the other

modem to channel A of the module interface

on the other chassis.

6. Test the modems.

Dial from the “local” modem to see if you can

communicate with the “distant” one. Then

reverse direction, dialing from the “distant”

chassis to the “local” one.

Repeat Steps 5–6 for channel B.

16.6 Drawings

The schematic for the Low Speed Data (232)

Module and interface is available upon request.

The location of each of the components on the

Low Speed Data (232) Module and interface are

shown at the end of this chapter.

Steps 1–4 are the same as for the “data flow”

test. If you have just done them for that test,

skip them here and begin with Step 5.

NOTE

Table 16–3. Supported Control Signals.

Data Flow DB-9 pin No. Data & Modem Control Signals Supported

IN 3 TX Transmit Data

OUT 2 RX Receive Data

IN 7 RTS Request to Send

OUT 8 CTS Clear to Send

IN 4 DTR Data Terminal Ready

OUT 6 DSR Data Set Ready

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 341 342

Pas de commentaire

RFL Communications 21 Sub-MUX Spécifications Page 210